With advanced digital temperature-sensing technology, the Super-Pro Air-Pro Fan Step Controllers are the perfect addition for any grower looking to regulate the output of in-line duct fans, keeping air flow under control.

Air-Pro is a 5-speed Fan Controller. It can automatically adjust the wind speed through software technology to maintain a constant temperature and control airflow. The Air-Pro Fan Speed Controller uses a heavy duty 5-step controller for reliability and quietness. Simply plug the fan into the controller, set the dials and let the on-board computer system do the rest!

The controller also has a PRO Function. Through the Photocell Sensor (Light Sensor), the Air-Pro can control humidity in the room by automatically adjusting the wind speed during the dark cycle.

Advanced digital temperature-sensing technology

• Advanced technology and high-end engineering
• Eliminates fan issues with buzzing and humming
• Accurate temperature readings
• Maintains a constant climate
• Simple to operate
• Regulates minimum and maximum fans speeds

Models:

• T1 – 4 Ampere, 900W load capacity
• T2 – 8 Ampere, 1800W load capacity
• T3 – 16 Ampere, 3600W load capacity

Set Up

• Connect the Temperature & Photocell Sensor
• Place the Temperature Sensor in the room. Do not place in direct airflow or directly under a light source
• Place the Photocell Sensor in the room, facing the light source. Do not yet remove the cap
• Connect the fans to the sockets
• Set the minimum fan speed with Dial 1
• Set the desired temperature with Dial 2
• Set the maximum fan speed with Dial 3
• Connect the Fan Controller to the mains power source

Please note: If the set minimum fan speed is greater than, or equal to, the set maximum fan speed, the controller will continue to run at the set maximum fan speed. If the sensor is not connected, the controller will always work at the set minimum speed.

Pro Function

• The PRO Function ensures extra air is refreshed at night, even when the air is at the desired temperature.
• The PRO Function can be used as a night mode, which is when high humidity occurs.
• When the cap is on the Photocell Sensor, the PRO Function will not be activated.
• Remove the cap from the Photocell Sensor to activate the PRO Function. Only use the PRO Function when humidity control is needed.
• As soon as the sensor detects that it is dark, the fan will run 1 step faster than the current setting, every hour, for 7 minutes at a time.
• When the light is turned on, the PRO Function will automatically switch off and the controller will run in normal mode.
• To disable the PRO Function, the device needs to be reset. This is done by unplugging from the mains power, replacing the cap, and plugging back in.

Contents:

• 1 x Fan Speed Controller
• 1 x Fuse
• 1 x Temperature & Photocell Sensor
• 6 x Screws
• 6 x Wall Plugs